Table of Contents
Advertisement
B B , , E E – – R R E E D D (+) 12V inputs 30A fused
See Finding the Wires You Need section of this guide for finding
the 12V constant power wire. Solder the two RED wires from
the control module to the 12V constant power wire and cover
the connection with electrical tape.
note: If the vehicle has two separate (+)12V feeds to the
ignition switch, connect one RED wire from the control
module to each of the vehicle's (+)12V feeds.
C C – – O O R R A A N N G G E E (+) output to accessory circuit
See Finding the Wires You Need section of this guide for finding
the accessory wire. Solder the ORANGE wire to the accessory
wire and wrap with electrical tape.
D D – – P P I I N N K K (+) output to ignition circuit
See Finding the Wires You Need section of this guide for finding
the ignition wire. Solder the PINK wire to the ignition wire and
18
warning! Before making any connection
to constant battery power make sure that
the two green 30 amp fuses are removed
from the fuse holders on the two thick red
wires. Failure to do so may cause fire or
shorting of sensitive electrical components.
© 2004 Directed Electronics, Inc.
Advertisement
Table of Contents
