I Programming Channel Names - Icom IC-208H Instruction Manual

5
MEMORY OPERATION

I Programming channel names

Each memory channel and the call channel can be pro-
grammed with an alphanumeric channel name for easy
recognition and can be indicated independently by channel.
Names can be a maximum of 6 characters— see the table
below for available characters.
(space) (+) (–)
(1) (2) (3)
(B) (C) (D)
(L) (M) (N)
(V) (W) (X)
[EXAMPLE]: Programming "CLUB" into memory channel 1.
Push
Push
31
(=) (✱) (/) ( () ( ))
(4) (5) (6) (7) (8)
(E) (F) (G) (H) (I)
(O) (P) (Q) (R) (S)
(Y) (Z)
Rotate
Repeat the
previous
steps.
q Push [S.MW•MW] momentarily.
• "!" and memory channel number blink.
w Rotate the tuning dial to select the desired memory or call
channel.
e Push [BAND] to select the memory name programming
condition.
(|) (0)
• Frequency readouts disappear and a cursor blinks.
r Rotate the tuning dial to select the desired character.
(9) (A)
• The selected character blinks.
t Push [SET•LOCK] to move the cursor to the right.
(J) (K)
y Repeat steps r and t until the desired channel names
are displayed.
(T) (U)
u Push [S.MW•MW] for 1 sec. to program the name and exit
the channel name programming condition.
Push
Push
"
"
Rotate
for 1 sec.
"
Beep
Beep
"
Beep
"