door lock harness wire connection guide
These door lock outputs are for Passive arming control of the factory door locks.
They can also be used to control the door locks with the ignition switch for vehicle
that do not have this feature in the factory RKE system.
___
GREEN
H3/A
___
H3/B
___
BLUE
H3/C
The control module can control 2 common power door lock types without any addition-
al parts. With certain vehicles, or if an actuator is to be installed, either a 451M Door
Lock Relay Satellite or two relays will be required. Refer to TechTips document 1041.
plug-in harnesses
super bright LED, 2-pin WHITE plug
The super bright LED operates at (+) 2 volt DC and plugs into the two-pin WHITE port.
Make sure the LED wires are not shorted to ground as the LED will be damaged.
Multiple LED's can be used, but they must be wired in series. The LED fits into a 9/32-
inch mounting hole. Be sure to check for clearance prior to drilling the mounting hole.
N N O O T T E E : : Never use a BLUE LED in combination with a RED LED.
© 2005 directed electronics, inc.
DIA-41
(-) Lock, (+) Unlock Output
Not Used
(-) Unlock, (+) Lock Output
21