Internal Programming Jumper; Zones - Viper 330V Installation Manual

internal programming jumper

A 10A fuse is used as both a fuse and a program jumper. This jumper determines the
light flash output polarity. In the (+) position, the on-board relay is enabled and the
unit will output (+)12V on the WHITE wire, H1/2. In the (-) position, the on-board
relay is enabled for (-) output on the WHITE wire, H1/2. To access the jumper, remove
the sliding door from on top of the control module, as shown below.

zones

Zone
Trigger Type
Number
1 Instant trigger
2 Multiplexed input
3 Two-stage, progresses from warning
to full alarm
4 Multiplexed
5 Two-stage (similar to zone 3)
N N O O T T E E : : The Warn Away
26
FUSE/JUMPER
(-) POSITION
response does not report on the LED.
®
FUSE/JUMPER
(+) POSITION
Input Description
Hood and/or trunk pin switches.
Heavy impact from on-board
Doublegurard ® shock sensor.
Door switch circuit.
Optional sensor, Inputs shorter than
0.8 seconds will trigger Warn Away
response, while inputs longer than
0.8 seconds will instantly trigger full
alarm.
Ignition input.
© 2005 directed electronics, inc.
®