Four-Pin Optional Sensor Harness; Red Wire; Black Wire; Blue, Green Wires - Viper 330V Installation Manual

four-pin optional sensor harness

RED wire

The red wire supplies constant power to the optional sensor.

BLACK wire

The black wire supplies ground to the optional sensor.

BLUE, GREEN wires

The blue and green wires are multiplex inputs. They are both tied to the same zone.
If an input of less than 0.8 seconds is supplied to either wire the Warn-Away
®
response will occur. An input longer than 0.8 seconds to either wire will initiate the
triggered sequence and report zone 4. This port can be used for optional sensors such
as: the 506T—glass breakage sensor, or the 504D—field disturbance sensor.

door lock learn routine

Before the unit will respond to the factory remote keyless system, it must learn the
polarity of the door lock wires. To learn the lock polarity:
N N O O T T E E : : It is important that all the INPUT signals to the control module are in the rest sta-
tus state (no activity) before entering the learn routine.
© 2005 directed electronics, inc.
23