Section 3: Installing The 7.2V Ni-Mh Battery Packs; Section 4: Adjusting The Transmitter - Pro Boat Miss Elam Owner's Manual

Section 3: Installing the 7.2V Ni-MH Battery Packs

Carefully remove the hatch from the hull .
The Pro Boat water-cooled ESC comes pre-wired with a Deans
connector . Use a 6-cell battery pack listed below for optimum
performance .
• PRB3316 7 .2V 5100mAh with Deans connector
OR
• 2-7 .4Volt 20C or higher 2S LiPo pack (DYN5360D)
Pro Boat offers a charge adapter (PRB3312) to allow you to charge the
batteries with Dean's connectors with conventional chargers that use
Tamiya connectors .
Follow the instructions included with your fast charger to ensure a
safe charge .
Note: Refer to the radio instructions for specific information on
transmitter setup .
Adjust both the Throttle and Steering trims to the center position . Turn
on the transmitter, then the ESC power switch . The ESC will beep until
you squeeze the throttle trigger, indicating full throttle . It may be
necessary to adjust the throttle trim knob to stop the propeller from
turning while the throttle trigger is in the neutral position .

Section 4: Adjusting the Transmitter

Throttle Trim
Attach the hook and loop material to the batteries and the
battery boxes .
Confirm that the switch inside the boat is in the "OFF" position . Install
two fully charged 7 .2V Ni-MH battery packs into the hull .
Adjust the rudder trim knob so that the rudder is centered prior to
operation . You may adjust this control to make the boat runs straight
during operation .
5
Steering Trim