Table of Contents
Advertisement
EN
Antenna Tube Installation
Install the receiver antenna in the tube as shown.
Keep the end of the antenna above the boat's
waterline to get the best transmitter reception.
Apply clear tape (DYNM0102), if desired.
Installing the Battery Pack
1. Loosen the 2 screws on the rear of the canopy.
2. Carefully lift the rear of the canopy and pull back to
disengage the 2 front pins from the hull.
6
NOTICE: Do not cut or kink the
receiver antenna or damage may
result.
3. Install the battery in the compartment. Secure it with
the hook and loop straps. If running your boat in
rougher water conditions, the use of Waterproof Hook
and Loop Tape (DYNK0300) may also be needed to
fully secure the battery.
4. Connect the battery pack to the ESC power
connector.
Tip: Move the packs forward or back to adjust the
center of gravity for your boat. Move the packs toward
the bow so the bow rides lower in the water. Move
the packs away from the bow so that the bow rides
higher in the water.
Blackjack 24
Advertisement
Table of Contents
