Pro Boat Miss Budweiser Owner's Manual
  1. Manuals
  2. Brands
  3. Pro Boat Manuals
  4. Toy
  5. Miss Budweiser
  6. Owner's manual

Pro Boat Miss Budweiser Owner's Manual

1/12-scale rtr nitro unlimited hydroplane
Hide thumbs Also See for Miss Budweiser:
Table of Contents

Advertisement

Quick Links

Download this manual
Miss Budweiser
1/12-Scale RTR Nitro Unlimited Hydroplane
Owner's Manual
Specifications
Overall Length ........................................................................... 27.5 in (698.5mm)
Beam ................................................................................................14 in (355.6mm)
Engine .............................................................................DYN .15 Marine w/Recoil
Radio System .......................................................................JR AM 75MHz Python

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Miss Budweiser and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Pro Boat Miss Budweiser

Summary of Contents for Pro Boat Miss Budweiser

  • Page 1 Miss Budweiser 1/12-Scale RTR Nitro Unlimited Hydroplane Owner's Manual Specifications Overall Length ................27.5 in (698.5mm) Beam ....................14 in (355.6mm) Engine ................DYN .15 Marine w/Recoil Radio System ...............JR AM 75MHz Python...

  • Page 2: Introduction

    When operating this model, stay clear of people, full-sized boats, stationary objects, and wildlife. Also, watch out for fishing lines that could get tangled in the propeller. It is preferable to operate the Pro Boat™ Miss Budweiser in low wake, low wind conditions and in areas free of people, objects, and wildlife. We also suggest that you do not run the Miss Budweiser in salt water.

  • Page 3: Table Of Contents

    Section 7: Maintainance ......................11 Replacement Parts ........................14 Additional Required Items Although the Miss Budweiser comes fully assembled and ready for action, you will need a few tools to get your boat ready to run: Blue Thunder 20% Fuel (quart) (DYN2320)

  • Page 4: Warranty Information

    Warranty Information Pro Boat™ guarantees this kit to be free from defects in both material and workmanship at the date of purchase. This warranty does not cover any parts damaged by use or modification. In no case shall Horizon Hobby’s liability exceed the original cost of the purchased kit. Further, Horizon Hobby reserves the right to change or modify this warranty without notice.

  • Page 5: Section 1: Receiver And Transmitter Battery Installation

    Section 1: Receiver and Transmitter Battery Installation Receiver Batteries  5. Remove the clear lid that covers the radio box.  1. Remove the two knurled aluminum nuts that secure the cockpit as shown. Pull the cockpit off the boat. ...
  • Page 6 Section 1: Receiver and Transmitter Battery Installation (cont.)  9. Re-install the tuned pipe mount. Transmitter Batteries  1. Remove the transmitter from the box  7. Re-install the battery holder back into the radio box and properly seal the radio box with clear tape.

  • Page 7: Section 2: Turn Fin

    (counterclockwise), or you could easily flip the boat. If you need to make a left turn, do so in the Miss Budweiser in an oval and in an area that will allow you to make right turns (clockwise). a large diameter turn at slow speeds.

  • Page 8: Section 5: The Dynamite .15S Marine Engine

    Section 5: The Dynamite .15S Marine Engine Water-Cooled Engine Note: When using the pull-starter, never pull the rope out to its Because the Dynamite® 15S engine is water-cooled full length as doing so can cause and not aircooled, make sure that you do not run damage and the rope may not the engine for an extended amount of time outside retract.
  • Page 9 Section 5: The Dynamite .15S Marine Engine (cont.) Breaking in Your Engine Needle Settings The first start-up of the engine is the most critical When adjusting the settings, always adjust the moment of the engine’s life, dictating how the engine needles in small increments, about 1⁄16 of a full will perform from that time forward.

  • Page 10: Section 6: Engine Troubleshooting Guide

    Wipe off any exhaust residue from the boat. If you set screws and bolts are tight before each operation have operated Miss Budweiser in salt water, it is of the boat will prevent many problems. suggested that you thoroughly rinse the deck, hull,...

  • Page 11: Section 7: Maintainance

    Section 7: Maintainance Lubrication It is important to lubricate the flex shaft of the Miss Budweiser with cable grease after every two hours of operation. Do not forget to do this. You can purchase this grease at your local hobby store. To lubricate the drive shaft, follow these simple instructions.
  • Page 12 Section 7: Maintainance (cont.)  6. Carefully re-install the flex shaft and nylon bushing, making certain that you correctly tighten the collet nut. Next, re-install the drive shaft and propeller and tighten set screws on the flats of the drive shaft. ...
  • Page 13 Appendix Photo 1 Photo 3 Exhaust Manifold Fuel Tank Water-Cooled Head Turn Fin Glow Plug Carburetor Water-Cooling Line Pull Starter Photo 2 Photo 4 Water Pick-Up Propeller Rudder 2.5mm Manifold Bolts...

  • Page 14: Replacement Parts

    Replacement Parts In the event that you need to purchase replacement parts for your engine or the Miss Budweiser, please see your local hobby store. You can also purchase them from Horizon Hobby by calling 1-800-338-4639 or shop online @ www.horizonhobby.com...
  • Page 15 Notes...
  • Page 16 © 2004, Horizon Hobby, Inc. 4105 Fieldstone Road Champaign, Illinois 61822 (877) 504-0233 www.horizonhobby.com #7381...

Table of Contents