Section 7: Handling Adjustment; Section 8: Maintenance; Section 9: Speed Control Programming - Pro Boat Miss Elam Owner's Manual

Operate your Miss Elam Brushless EP in low to medium wake
conditions to avoid having problems with the boat overturning .
You may also turn the dual rate dial down to reduce rudder travel in
rough water conditions .
Before and at the end of each run, make sure all screws are tight and
the propeller is free from any entanglement .
The ESC in your Miss Elam Brushless EP is preprogrammed from the
factory . The programming is set for Ni-MH batteries as shipped with
your Miss Elam .
A programming module (PRB3311) is available to change the
programming of your speed control . Settings include Ni-MH or Li-Po
batteries, cutoff voltage settings, cutoff type, brake on or off, motor
timing and throttle curve . The brake and motor timing adjustments can
be adjusted without the programming module . See the ESC
instructions for details .
NOTICE: It is imperative that you do not attempt to use Li-Po
batteries in the Miss Elam Brushless unless it has been properly
programmed or serious damage to the batteries and electronics
may occur .

Section 7: Handling Adjustment

Section 8: Maintenance

Section 9: Speed Control Programming

Steering Dual Rate
7