Chapter 2 : Preparations; Preparing A Power Supply; Using A Battery Pack - Sony PDW-F800 Operation Manual

2 Preparations
Chapter
Preparing a Power
Supply
For safety, use only the Sony battery packs and
AC adaptors listed below.
• BP-GL95/GL65/L60S/L80S Lithium-ion
Battery Pack
• AC power using the AC-DN2B/DN10 AC
Adaptor

Using a battery pack

When a BP-GL95/GL65/L60S/L80S Battery
Pack is used, the camcorder will operate
continuously for the time shown below.
Model name Operating time
BP-GL95 Approx. 120 minutes
BP-GL65 Approx. 75 minutes
BP-L60S Approx. 75 minutes
BP-L80S Approx. 100 minutes
WARNING
Batteries shall not be exposed to excessive heat
such as sunshine, fire or the like.
AVERTISSEMENT
N'exposez pas les batteries à une chaleur
excessive, au soleil ou près d'un feu par exemple.
WARNUNG
Akkus dürfen keinesfalls übermäßiger
Wärmeeinwirkung ausgesetzt werden, wie z.B.
Sonneneinstrahlung, Feuer o. ä.
Note
The battery pack operating time depends on the
frequency of use of the battery pack, and the ambient
temperature when used.
Before use, charge the battery pack with a charger
suitable for each battery.
For details on the battery charging procedure, refer
to the battery charger operation manual.
Note on using the battery pack
A warm battery pack may not be able to be fully
recharged.
To attach the battery pack
1
Press the battery pack against the back
of the camcorder, aligning the line on
the side of the battery pack with the
matching line on the camcorder.
1 BP-GL95/GL65/L60S/L80S
2 Align these lines.
2
Slide the battery pack down until its
"LOCK" arrow points at the matching
line on the camcorder.

Preparing a Power Supply

1
2
39