Sony PDW-F800 Operation Manual page 19

FILTER selector
(outer knob) setting
A
B
C
D
a) A type of special effect filter. A cross of light appears
in the highlight section.
FILTER selector
(inner knob) setting
1
2
3
4
[700]
The PDW-700 is equipped with one switchable
filter. It is possible to switch between four ND
filters.
FILTER selector
setting
1
2
3
4
For the PDW-700, you can change a
MAINTENANCE menu setting so that different
white balance settings can be stored for different
FILTER selector positions. This allows you to
automatically obtain optimum white balance for
the current shooting conditions in linkage with
the filter selection.
For details, see "Adjusting the white balance" on
page 62.
CC filter
a)
Cross filter
3200K
4300K
6300K
ND filter
CLEAR (no filter)
1
/ ND (reduces the
4
amount of light to about
1
/ )
4
1
/ ND(reduces the
16
amount of light to about
1
/ )
16
1
/ ND(reduces the
64
amount of light to about
1
/ )
64
ND filter
CLEAR
1
/ ND (attenuates light
4
1
to approximately / )
4
1
/ ND (attenuates light
16
1
to approximately / )
16
1
/ ND (attenuates light
64
1
to approximately / )
64
d MENU knob
Changes the page selection or a setting within the
menu.
For details about how to use the MENU knob, see
"Menu Operations" on page 206.
e EARPHONE jack (monaural,
minijack)
You can monitor the E-E
recording and playback sound during playback.
When an alarm is indicated, you can hear the
alarm sound through the earphone. You can use
this with the EARPHONE jack on the rear of the
unit at the same time. Plugging an earphone into
the jack automatically cuts off the built-in
speaker.
1) E-E: Abbreviation of "Electric-to-Electric". In E-E
mode, video and audio signals input to the camcorder
are output after passing through internal electric
circuits only. This can be used to check input signals.
f AUTO W/B BAL (automatic white/
black balance adjustment) switch
Activates the automatic white/black balance
adjustment functions.
WHT: Adjusts the white balance automatically.
If the WHITE BAL switch (see page 21) is
set to A or B, the white balance setting is
stored in the corresponding memory. If the
WHITE BAL switch is set to PRST, the
automatic white balance adjustment function
does not operate.
BLK: Adjusts the black set and black balance
automatically.
g MIC (microphone) LEVEL control
Adjusts the input level of audio channels 1, 2, 3
and 4.
For details, see "Adjusting the Audio Level" on page
73.
Locations and Functions of Parts and Controls
1)
sound during
19