Basic Procedure for
This section describes the basic procedures for
shooting and recording.
Before a shooting session, ensure that the
camcorder is functioning properly.
For details, see "Testing the Camcorder before
Shooting" on page 257.
Basic procedure for shooting: from power
supply to disc loading
Attach a fully charged battery pack.
For details, see "Preparing a Power Supply" on
Set the POWER switch to ON.
Press the DISP SEL/EXPAND button to
switch the LCD monitor to status
display, and check that the following
conditions are met.
• The HUMID indicator is not showing.
If it is, wait until it disappears.
• The battery status indicator shows at least
five segments (x).
If it does not, replace the battery pack with
a fully charged one.
Basic Procedure for Shooting
Check that there are no obstructions
such as cables near the disc
compartment lid. Then press the
EJECT button to open the disc
After checking that the disc is not write-
protected (see page 80), load it and close
the disc compartment lid.
Basic procedure for shooting: from
adjusting the black balance and white
balance to stopping recording
After turning on the power and loading a disc, set
the switches and selectors as shown below and
1 DISPLAY: ON
2 Iris: Automatic
3 Zoom: Automatic
4 OUTPUT/DCC: CAM, DCC: ON
5 F-RUN/SET/R-RUN: F-RUN or R-RUN
(set as needed)
6 AUDIO SELECT CH-1/CH-2: AUTO