Sony PDW-F800 Operation Manual page 227

Wi-Fi>SSID
SSID:?
!#$%&"()+.-,0123456789:
=@ABCDEFGHIJKLMNOPQRSTUV
WXYZ[]^_abcdefghijklmnop
qrstuvwxyz{}~
INS DEL RET
See steps 3 and 4 in "Setting the shot ID" (page 218)
for information about how to enter characters.
To set ENCRYPTION options
Depending on the setting of ENCRYPTION, you
must set the following options.
When ENCRYPTION is WEP:
Item name Setting
WEP KEY INDEX 1 to 4
INPUT SELECT ASCII5: 5 characters ASCII
(network key format
and length) ASCII13: 13 characters
HEX10: 10 hexadecimal
HEX26: 26 hexadecimal
KEY (network key) ASCII characters or
hexadecimal number (format
specified with INPUT
SELECT)
When ENCRYPTION is TKIP or AES:
Item name Setting
INPUT SELECT ASCII8-63: 63 characters
(network key format
and length) HEX64: 64 hexadecimal
KEY (network key) ASCII characters or
hexadecimal number (format
specified with INPUT
SELECT)
See steps 3 and 4 in "Setting the shot ID" (page 218)
for information about how to enter the key.
To specify a connection destination by
WPS operations
In infrastructure mode only, you can use WPS
(Wi-Fi Protected Setup) to specify a connection
destination (access point) semi-automatically.
RET
ESC END
format
ASCII format
digits
digits
ASCII 8-bit format
digits
Notes
• WPS does not support the following.
- Ad hoc mode
- IEEE 802.1x
• The access point must support WPS.
• In addition to the settings made here, you must also
make network settings on the NETWORK page of the
MAINTENANCE menu.
(How to select an item in the menu screen: Turn
the MENU knob to move b to the desired item.)
1
Display the WPS page of the
MAINTENANCE menu and then press
the MENU knob.
See "Basic menu operations" (page 206) for
more information about menu operations.
2
Select "ENABLE" and then press the
MENU knob.
The screen changes to the operation screen.
M25 WPS
Wi-Fi
WPS MODE
WPS START
WPS STATUS
3
Set WPS MODE to one of the following.
ONE PUSH: Connect using the one push
method
PIN CODE: Connect using the PIN code
entry method.
When you select "PIN CODE"
A PIN item appears. Execute "UPDATE" in
that item to display a PIN code for this unit.
4
Select "WPS START" and then press
the MENU knob.
WPS setup starts. During execution, the
progress and results appear after WPS
STATUS.
SCANNING: Scanning for an access point
OK: Detection successful
NG: Detection failed
When execution finishes, the screen changes
to the ACCESS PNT page.
Adjustments and Settings from Menus
TOP
: ENABL
: ONE PUSH
: EXEC
: -----
227