Section 12-Electronics; Disconnecting/Connecting The Joystick; Disconnecting; Connecting - Invacare Pronto M91 Service Manual

SECTION 12—ELECTRONICS
SECTION 12—ELECTRONICS
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the OFF position.

Disconnecting/Connecting the Joystick

NOTE: For this procedure, refer to FIGURE 12.1.

Disconnecting

MKIV RII/MK5 Joysticks
1. Loosen the thumb screws on the joystick connector.
2. Disconnect the joystick connector from the controller connector.
MKIV "A" Joystick
1. Loosen the threaded collar on the joystick connector.
2. Disconnect the joystick connector from the controller connecter.

Connecting

MKIV RII/MK5 Joysticks
1. Align the joystick connector with the controller connecter.
2. Secure the joystick connector to the controller connector using the thumb screws on
the controller connector.
MKIV "A" Joystick
1. Align the joystick connector with the controller connecter.
2. Secure the joystick connector to the controller connector using the threaded collar on
the controller connector.
The excess joystick cable must be coiled, and tie-wrapped to the rear of the seat
frame to ensure that cable does NOT become entangled or damaged during normal
operation of seating system - otherwise injury or damage may result.
® ™
Pronto M91 and M94
WARNING
WARNING
92
Part No. 1125038