Removing/Installing Drive Lockout Switch Mounting Hardware And Cable (Full Recline Van Seat Only) - Invacare Pronto M91 Service Manual

SECTION 4—SEAT
Removing/Installing Drive Lockout Switch Mounting
Hardware and Cable (Full Recline Van Seat Only)
NOTE: For this procedure, refer to FIGURE 4.14.
NOTE: Reverse this procedure to install the drive lockout switch mounting hardware.
1. Place the wheelchair in a well ventilated area where work can be performed without
risking damage to carpeting or floor covering.
2. Verify the joystick ON/OFF switch is in the OFF position and disconnect joystick cable.
3. Lift up on the release handle and recline seat back to 170°.
4. Remove the two (2) mounting screws and washers securing the drive lockout switch
cable to the seat.
5. Lift up on the release handle and return the seat to the upright position.
6. Remove the seat. Refer to Removing/Installing or Tilting the Seat Assembly on
page 30.
7. Remove the batteries. Refer to Installing/Removing the Batteries on page 83.
NOTE: By this step the rear and top shrouds should be open and the drive lockout switch cable
should be disconnected (connector is located next to charger).
NOTE: Tie-wraps that secure the auxiliary power connectors and drive lockout cable are also used
to secure the charger cable lead to the wheelchair frame.
8. Cut the three (3) ties-wrap that secure the auxiliary power connectors and drive
lockout cable to the wheelchair frame (Detail "A" of FIGURE 4.14).
NOTE: After disconnecting the drive lockout cable, ensure the charger cable is securely connected
to the auxiliary power connectors.
9. Disconnect the drive lockout cable from the auxiliary power connectors.
10. Remove drive lockout cable from the wheelchair frame.
® ™
Pronto M91 and M94
48
Part No. 1125038