Description Of Camera Parts - Okina WDE-7680 User Manual

2.2 Description of Camera Parts

(1)
Lens Mount
This mount is used to install a CS-mount lens. CS-adaptor ring is required when using a C
mount lens.
(2)
Camera Mounting Screw Holes
Screw hole for mounting the camera.
(3)
Mount Adaptor
The adaptor can be attached onto the top or the bottom of the unit.
(4)
Auto Iris Lens Connector (4-pin type)
The lens connector supplies the auto-iris lens (not supplied) with DC control signal.
PIN NO. VIDEO
1 DC + 12V
2
3
4
(5)
S-Video Output Terminal
Separate Y (brightness) and C (color) signal are outputs from this terminal to obtain better
video quality at a video monitor.
1. C signal: 0.3V (p-p), 75Ω, unbalance
2. Y signal: 1.0V (p-p), 75 Ω, unbalance, negative synchronizing
3. C signal Ground
4. Y signal Ground
(6)
Iris Mode Selection Switch
Select DC or VIDEO mode according to the lens.
(7)
OSD Control Buttons
ENTER button
UP & DOWN buttons
LEFT & RIGHT buttons
(8)
Video Connector
Video can be outputted via this BNC connector (75Ω).
Copyright © 2010. All Rights Reserved.
www.okinausa.com
DC
CONTROL -
NC CONTROL +
IRIS DRIVE +
GND DRIVE -
4
AC24V
REV122010-V17