Chapter 2 - Operation; Introduction; Installation; Ac Power Considerations - ILX Lightwave LDT-5525 User Manual

Chapter 2
OPERATION

2.1 Introduction

This chapter describes how to install, adjust, and operate the LDT-5525 Temperature Controller. It is divided into
sections covering installation, familiarization and adjustment, and normal operating procedures.
Section 2.4 gives an overview of the LDT-5525's front panel features, and it presents a guide to quickly familiarize the
user with the front panel operations.

2.2 Installation

Installation procedures and considerations are covered in Sections 2.2.1 - 2.2.2.

2.2.1 AC Power Considerations

The LDT-5525 Series Controllers can be configured to operate at nominal line voltages of 100, 120 220, 230-240 VAC
(all ±10%). This is done at the factory and need not be changed before operating the instrument. However, check to
be sure that the voltage printed on the back panel of the instrument matches the power-line voltage in your area.
WARNING
To avoid electrical shock hazard, connect the instrument to properly earth-grounded,
3-prong receptacles only. Failure to observe this
precaution can result in severe injury or death.
2-1