Table of Contents
Advertisement
This chapter is an overview of the operation of the LDT-5416 Thermoelectric Temperature
Controller.
Power requirements
Front panel operation
General operating procedures
Grounding Requirements
The LDT-5416 Thermoelectric Temperature Controller comes with a three conductor AC power
cable. The power cable must be plugged into an approved three-contact electrical outlet or used
with a three-contact to two-contact adaptor with the grounding wire connected to an electrical
ground (safety ground). ILX Lightwave recommends connecting the instrument only to properly
earth grounded receptacles. The power cord connector and provided power cable meet IEC
safety standards.
AC Line Power Requirements
The LDT-5416 Thermoelectric Temperature Controller features a universal input and can be
operated at nominal line voltages of 90 - 240 VAC and 50 – 60 Hz.
The Power Up Sequence
Prior to power up ensure that the ventilation holes located on the left and right hand side
as well as on the top of the instrument have no obstructions that would impede airflow.
With the LDT-5416 connected to an AC power source, pressing POWER supplies AC line power to
the instrument. After power-up, make sure that the OUTPUT is off (LED unlit) until you have
configured the instrument for your application.
November 2016
General Operation
5
Chapter 2:
LDT-5416
Advertisement
Table of Contents
