Installing A Rope Clip - IBM 2292 User Manual

5. If you have a CD-ROM audio cable, connect it to the drive and to the system
To connect an additional IDE CD drive or DVD drive
1. Locate the secondary IDE connector on the system board and the
2. Connect the extra connector in the signal cable to the new CD drive or DVD
3. Your computer has extra power connectors for additional drives. Connect a
To connect an additional IDE hard disk drive
1. Locate the primary IDE connector on the system board. One end of the
2. Connect the extra connector in the signal cable to the new hard disk drive.
3. Your computer has extra power connectors for additional drives. Connect a

Installing a Rope Clip

To help prevent hardware theft, you can add a 3/16 inch or 5 mm Rope Clip and
cable to your computer. After you add the security cable, make sure that it does
not interfere with other cables that are connected to the computer.
To install a Rope Clip:
1. Remove cover (see "Removing the cover" on page 41).
2. Use a tool, such as a screwdriver, to remove the two metal knockouts.
3. Insert the Rope Clip through the rear panel; then attach and tighten the nuts
4. Replace the computer cover. For more information, see "Replacing the cover
board. See "Identifying parts on the system board" on page 43.
three-connector signal cable. See "Identifying parts on the system board" on
page 43.
drive.
power connector to the drive.
three-connector cable connects to the hard disk drive and the other connects to
the system board. See "Identifying parts on the system board" on page 43.
power connector to the drive.
What to do next
v To work with another option, go to the appropriate section.
v To complete the installation, go to "Replacing the cover and connecting the
cables" on page 52.
with an appropriately sized or adjustable wrench.
and connecting the cables" on page 52.
Chapter 5. Installing internal options — microtower model
51