Gefen Pro GEF-DVI-848DL User Manual page 54

l Command
The l (lower-case "L") command displays the link status of each input. If the
input is receiving a dual-link signal, then the Link status will be set to "Dual". If a
single-link source is used, then the Link status will be set to "Single".
Syntax:
l
Parameters:
None
Example:
l
Input | Signal
--------|----------|--------
1 |
2 |
3 |
4 |
5 |
6 |
7 |
8 |
--------|----------|--------
TELNET / RS-232 COMMANDS
| Link
NONE | Single
NONE | Single
NONE | Single
NONE | Single
NONE | Single
NONE | Single
NONE | Single
NONE | Single
50