Table of Contents
Advertisement
r Command
The r command routes the specified input to the specified output(s).
Up to eight outputs can be specified, beginning with param2.
Syntax:
r param1 param2 [param3...param9]
Parameters:
param1
param2
Notes:
If param2 = 0, then the specified input is routed to all outputs. If additional
outputs are specified, then they are ignored.
Examples:
r 7 3 4 5 6 1 2
Input 7 is routed to outputs: 3 4 5 6 1 2
If Dynamic EDID (see page 18) is enabled, then the last output in the list will be
saved to the specified input (param1), as shown below:
r 7 3 4 5 6 1 2
Input 7 is routed to outputs: 3 4 5 6 1 2
Finished reading EDID from output 2
Finished loading EDID to local 7
r 1 0
All outputs are routed to input 1
TELNET / RS-232 COMMANDS
Input
Outputs
39
[1 - 8]
[0 - 8]
Advertisement
Table of Contents
