Table of Contents
Advertisement
#set_telnet_pass Command
The #set_telnet_pass command sets the Telnet password. The maximum length
of the password is 20 characters. The password is case-sensitive.
Syntax:
#set_telnet_pass param1
Parameters:
param1
Notes:
The default password is Admin.
The matrix must be rebooted after executing this command.
Example:
#set_telnet_pass reindeer
Telnet password updated to: reindeer
#set_telnet_port Command
The #set_telnet_port command sets the Telnet listening port.
Syntax:
#set_telnet_port param1
Parameters:
param1
Notes:
The default port setting is 23.
The matrix must be rebooted after executing this command.
Example:
#set_telnet_port 80
New Telnet port set to: 80
TELNET / RS-232 COMMANDS
Password
Port
31
[0 - 65535]
Advertisement
Table of Contents
