Table of Contents
Advertisement
f Command
Enables / disables 5V on pin 14 of the specified DVI input. This command is
used when connecting the Receiver module of fiber optic extenders, which
require 5V.
WARNING: Before connect a computer to the DVI input, make
sure to disable the 5V on the DVI input. Otherwise, the video
card on the computer may become damaged.
Syntax:
f param1 param2
Parameters:
param1
param2
Example:
f 1 1
Enable FO 1
TELNET / RS-232 COMMANDS
Input
State
State
Meaning
0
Disable 5V
1
Enable 5V
49
[1 - 8]
[0 - 1]
Advertisement
Table of Contents
