Network Status - Lucom ER 75i User Manual

4.1. Network Status

To view
the System Information menu item. The bottom part of the window contains information about
the system memory usage. The upper part of the window displays detailed information about
active interfaces:
•
eth0 – parameters of networks interface
•
ppp0 – PPP interface (active connection to GPRS/EDGE)
•
tun0 – OpenVPN tunnel interface
•
gre1 – GRE tunnel interface
•
ipsec0 – IPSec tunnel interface
By each of the interfaces are then shown the following information
•
HWaddr – hardware (unique) address of networks interface
•
inet – own IP address
•
P-t-P – IP address second ends connection
•
Bcast – broadcast address
•
Mask – mask of network
•
MTU – maximal size of packet, which is equipment able transmit
•
Metric – number of routers, over which packet must pass
•
RX packets – received packets, errors – number of errors, dropped – dropped
packets
•
TX packets – transmit packets, errors – number of errors, dropped – dropped packets
•
collisions – number of collisions
•
RX bytes – total number of received bytes
•
TX bytes – total number of transmit bytes
It is possible to elicit GPRS connection state from the network information. If the GPRS
connection is active, then it is in the system information shown as ppp0 connection.
33
LUCOM GmbH * Ansbacher Str. 2a * 90513 Zirndorf * Tel. 09127/59 460-10 * Fax. 09127/59 460-20 * www.lucom.de
the system information
CONFIGURATION
about the modem operation, select