What To Do If; Initialization Is Not Performed Or Initialization Fails; The Imodela Controller Does Not Operate Correctly; Operations Are Ignored - Roland iModela iM-01 Master Manual

What to Do If

Initialization Is Not Performed or Initialization Fails

Is a large amount of cutting waste present?
Clean away any cutting waste. Clean the area around the spindle head especially carefully.
 P. 35, "Cleaning and Gleasing"
Is anything caught on the spindle head or table?
Check whether something has become caught and is impeding initialization.

The iModela Controller Does Not Operate Correctly

Has the cutting machine been initialized?
Initialize the cutting machine, and then start the iModela Controller.
 P. 6, "Starting the Machine"
Is the machine connected to the PC?
Check whether the cable connecting these devices has come loose.
 "First Step Guide"
Is the driver installed correctly?
If the connection to the PC is not made in the sequence described, the driver may not be installed correctly.
The iModela Controller does not function normally if the driver is configured incorrectly. Check again to ensure
that the connection was made using the correct procedure.
 "First Step Guide," p. 56, "The iModela Driver Cannot Be Installed"

Operations Are Ignored

Is anything caught on the spindle head or table?
Check whether something has become caught and is impeding operations.
Is the cable connected?
Connect the cable securely.
 "First Step Guide"
Was the machine started according to the correct procedure?
Initialize the cutting machine, and then start the iModela Controller.
 P. 6, "Starting the Machine"
Are any of the LEDs on the machine flashing rapidly?
 P. 50 "The LED Beside the Power Button Is Flashing"
48
Chapter 4 Appendix