Loading The Firmware To The Hdmi Da2 - Extron electronics HDMI DA2 User Manual

Loading the Firmware to the HDMI DA2

To load a new version of firmware to the switcher using Firmware Loader, connect the
control PC to the HDMI DA2. You may use the front panel USB config port or the rear
panel 3‑pole captive screw Remote port (see
information on connecting to the serial port).
1.
2.
3.
4.
5.
6.
7.
8.
If you have not already done so, download and install the Firmware Loader executable
installer file to your computer (see
on the previous page).
If necessary, download the latest version of HDMI DA2 firmware and install it on your
computer (see Downloading HDMI DA2 Firmware
Open the Firmware Loader via your desktop
selections:
Start > All Programs > Extron Electronics > Firmware Loader > Firmware
Loader
The Firmware Loader window opens with the Add Device window displayed in front of
it.
Figure 10. Opening Firmware Loader
On the Add Device window, select
menu.
From the
Connection Method
Depending on the connection method that you selected, additional options appear.
Make the appropriate selections for your connection method.
: Select the appropriate options from the
RS-232
z
menus (this information is provided by your system administrator).
: Only the
USB Extron USB Device_0
z
menu. Make sure that it is selected.
Available Devices
Click . If the connection is successful, HDMI DA2 is displayed in green in the
Connect
Connected Device section, followed by a green check mark.
Click the button in the New Firmware File (Optional) section.
Browse
Wiring for RS-232 Control
Downloading and Installing Firmware Loader
on the previous page).
menu by making the following
Start
from the
HDMI DA2 Device Names
drop‑down menu, select either
Com Port
option is available on the
HDMI DA2 • Updating Firmware
on page 6 for
drop‑down
or .
RS-232 USB
and
Baud Rate
21