Table of Contents
Advertisement
Timer Mode
Manual Mode
Timer Mode
Parameters
Atmos™ User Manual Rev. 1
When in Timer mode, the Atmos™ will produce fog in pre-configured time intervals
defined by the Interval Set and Duration Set menu options. In addition, the output volume
during Timer mode is set by the Timer Out menu option. See the
section for details about how to configure these parameters.
To operate in Timer mode, do the following:
1. Press <TIMER> and the display will show a countdown of the interval timer.
2. When the counter reaches zero (0), the Atmos™ will start producing fog.
3. The fog output duration during Timer mode is set by the Duration Set menu option.
4. The fog output volume during Timer mode is set by the Timer Out menu option.
5. This cycle will repeat itself until you press <TIMER> again or until the Atmos™ runs
out of fluid.
In the Manual mode, the Atmos™ will output fog for as long as <MANUAL> remains
pressed. The output volume will be at 100% full fog output.
To operate in Manual mode, do the following:
·
Press <MANUAL>.
This mode will continue until you release <MANUAL> or until the Atmos™ runs out of
fluid.
These parameters determine the intervals and output volume for the Atmos™ while in
Timer mode.
To configure these parameters do the following.
1. Press <FUNCTION> repeatedly until Interval Set shows on the display.
2. Use <UP> or <DOWN> to select the time in seconds (1–200s) between fog output.
3. Press <FUNCTION> repeatedly until Duration Set shows on the display.
4. Use <UP> or <DOWN> to select the time in seconds (1–200s) for the duration of the
fog output.
5. Press <FUNCTION> repeatedly until Timer Out shows on the display.
6. Use <UP> or <DOWN> to set the fog output volume (1–100%).
Operation
Timer Mode Parameters
-11-
Advertisement
Table of Contents
