Table of Contents
Advertisement
in the printer, the printer stops printing until you load the specified
paper size. The message
LOAD UPPER TRAY PAPER SIZE
displays on the control panel. SIZE is the paper size.
Using VMS Commands
If you are connected to the printer through a DECnet network, you
can use the VMS PRINT command parameter SHEET_SIZE to select
paper size.
The following is the PRINT command for paper size selection:
$ PRINT/PARAM=(SHEET_SIZE= size ) filename
Your choices for size are letter, legal, a4, quarto, commercial,
foolscap, folio, and legalsmall. (See the VMS Interface for QMS Print-
ers manual for complete information about using PRINT parameters.)
If you use a value for size that is not loaded in the printer, but is a size
for which the printer is configured, the printer stops printing until you
load the specified paper size. If you use SHEET_SIZE and
INPUT_Input bin, the paper size specified by SHEET_SIZE must
match the paper loaded in INPUT_Input bin. If it does not, the printer
stops printing, displays an error message, and waits for the correct
paper size to be loaded in the specified paper input bin.
Manual Feed
You must use the manual feed slot to print on the following. (For more
information on special media, see appendix B, "Technical Specifica-
tions.")
Transparency film
Paper 13-16 lbs (50-60 g/m
Paper 32-45 lbs (120-170 g/m
Plain color/embossed 45 lb (170 g/m
Printing Your Files
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
2
)
2
)
2
) paper
Feeding Paper
5-7
Advertisement
Table of Contents
