Adjusting The Paper Size Switch - QMS 4525 User Manual

Adjusting the Paper
Size Switch

Adjusting the Paper Size Switch

If you have the stacker/stapler installed, a device in the upper output
bin taps printed sheets into a neat stack. For this to work properly, the
paper-size switch must be set to the correct paper size. The switch
has three positions:
Left
Center
Right
When you load paper into the
input bins, check the paper
size switch setting to ensure
that it is set properly. If you
load paper of different sizes in
the two input bins, set the
switch to the widest size.
4-12
7 Replace the toner bin lid, and push the developing
unit back into its home position.
8 Pull the green handle toward you, then turn it 180°
clockwise until the tab seats into the square hole in
the metal handle of the developing unit.
9 Close the front door.
Foolscap (8.0", 203 mm)
Quartol (8.0", 203 mm)
A4 (8.3", 210 mm)
Commercial (8.3", 210 mm)
Folio (8.3", 210 mm)
Letter (8.5", 216 mm)
Letter Large (8.5", 216 mm)
Legal Small (8.5", 216 mm)
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
QMS 4525 Print System User's Guide