Plugging In The Printer; Loading Media Into The Printer; Printer Operation Problems - Intermec EasyCoder 3400e User Manual

EasyCoder 3400e Bar Code Label Printer User's Manual
Printer Operation Problems (continued)
Symptom Possible Causes
Labels stop feeding You have set the printer for
through the printer. continuous label stock.
(continued)
Media is sticking to the paper path.
Printer slows down. You have incorrectly set the image
bands or print speed.
Printer has aborted and reset the
print speed and image bands.
Labels stick to door The self-strip roller is dirty.
or fail to strip.
The Alert LED Printhead has overheated.
flashes and printing
stops.
Media fault. The printhead is up.
Sensor type set incorrectly.
You have incorrectly loaded the
media.
Test configuration You have incorrectly loaded the
label does not print. media.
You have configured the printer for
self-strip media.
Media fault.
4-4
NugFont
HelvC
Solution
Use PrintSet to check the configuration settings. If
the settings are incorrect, use PrintSet to change the
settings.
Clean any extraneous material from the paper path
and clean the path thoroughly. Refer to Chapter 3,
"Maintaining the Printer."
Use PrintSet to change the image bands or print
speed settings.
Use PrintSet to change the image bands or print
speed settings.
Clean the self-strip roller. See Chapter 3,
"Maintaining the Printer."
Leave printer alone until it has time to cool down. It
will resume printing on its own.
Make sure the printhead is down. The head lift lever
should be straight up and down. Press the Feed/Pause
button to resume printing.
Configure the printer for the correct sensor for the
Print mode you are using. You can enable self-strip
and other Print modes from PrintSet.
Try reloading the media. For help, see "Loading
Media Into the Printer" in Chapter 2.
Try reloading the media. For help, see "Loading
Media Into the Printer" in Chapter 2.
Set the printer to the default configuration using the
DIP switches. For help, see "Plugging In the Printer"
in Chapter 1.
Remove media from under the label taken sensor.
C 39