Loading Media For Self-Strip Printing - Intermec EasyCoder 3400e User Manual

Loading Media for Self-Strip Printing

5. Unscrew the edge guide and slide it to the outer edge of the lower media guide.
6. Pull down on the lower media guide to allow easy access to the media path.
7. Unroll several inches of media, insert it between the upper media guide and the
8. Release the lower media guide and adjust the edge guide to position the media
9. Pull out 25.4 to 30.48 centimeters (10 to 12 inches) of media and remove the
10. Open the media access door and thread the media liner under the self-strip assist
11. Remove the clasp from the rewinder hub and wind approximately 5.08 centimeters
NugFont
HelvC
P o
w e
r /D
a ta
A le
r t
E m
p t
y /
P a
u s
e
F e
e d
/ P
a u
s e
I n t e I n t e
r m e r m e
c c
3 4
0 0
Media
liner
Media
access door
Self-strip
assist roller
Screw it in place.
Note: If you are replacing the empty media roll with a new roll of the same width,
you do not need to adjust the edge guide.
lower media guide, and out the front of the printer.
firmly against the inside wall of the printer.
exposed labels from the media liner.
roller and over the rewinder hub in a clockwise direction.
(2 inches) of media liner clockwise over the rewinder hub.
C 39
Operating the Printer
Lower media
guide
Edge
guide
Rewinder
Head lift
hub
Rewinder
lever
clasp
2
Media roll
Supply roll
retainer
Supply roll
post
Media
support
Upper
media
guide
3XXXU.027
2-9