Swiss Movado Operating Instructions Warranty & Service Manual page 26

day of the week will appear automatically as part of
the perpetual calendar function.
Using the countdown timer:
1. Select the Timer TM function.
2. Pull crown out to position 2: The numerals indicating
hours and minutes start to flash in lower display.
3. Turn crown in either direction to set how much time
you want to count down: A rapid rotation changes
the hours; a slow rotation changes the minutes.
4. Push crown back in to position 1 (neutral position):
The countdown function starts automatically; the
watch alarm will ring when the preset time period
has elapsed.
5. Push crown in to position 0 to stop the alarm.
NOTE: The countdown function can be cancelled at any
time by pushing the crown in to position 0 and holding
it down for more than 2 seconds. A running countdown
can be restarted by pushing the crown in once.
Displaying the time in another time zone:
In addition to the local time, you can display the time
in a second time zone with this timepiece:
1. Select the Second Time Zone T2 function.
2. Pull crown out to position 2: The numerals indicating
hours and minutes for the second time zone start to
flash in lower display.
3. Turn crown in either direction to change the flashing
settings: A rapid rotation changes the hours; a slow
rotation changes the minutes.
4. Push crown back in to position 1 (neutral position).
NOTES: The seconds display cannot be adjusted for
a second time zone: the display will show the same
seconds as the local time setting.
The time zone display is corrected in ½-hour increments.
When reading the time shown for a second time zone,
you'll need to take into account whether the watch is
operating in 12-hour (AM/PM) or 24-hour mode.
ANA-DIGI QUARTZ CHRONOGRAPH
1/100 OF A SECOND
Includes the Movado Dura ana-digi quartz chronograph
Changing the time zone:
When you change the time zone, or in the event
automatic daylight savings time changes do not occur,
you may adjust the hour indicated by the lower digital
display and analog watch hands forward or back by
several hours without affecting the digital minutes and
seconds display. To do so:
1. Select and display local time.
2. Pull crown out to position 2: the symbol T appears
in upper display; the numerals indicating hours and
minutes flash in lower display.
3. Turn crown rapidly in either direction to change the
lower digital hour display; the analog watch hands
will move simultaneously to synchronize with the
digital display.
4. When correct hour appears in lower digital display,
push crown back to position 1.
NOTE: In the event that the movement does not adjust
automatically for a daylight savings time change,
you will also need to adjust the second time zone
accordingly.
USING THE CHRONOGRAPH
Overview
This digital chronograph may be used to time an event
up to 47 hours, 59 minutes and 59.99 seconds in
duration in one of two modes.
To operate the Chronograph, select the Chronograph
function CHR in either the ADD (Ad) Mode (to take an
accumulated time reading) or the SPLIT (SP) Mode (to
measure intermediate times during an ongoing event.)
The chronograph counter is started/stopped/restarted
by consecutive pushes on the crown.
To reset the digital display counter to zero, push the
crown and hold it down for more than 2 seconds.
25