Swiss Movado Operating Instructions Warranty & Service Manual page 18

Includes the original Series 800 sport and sport elegant quartz chronographs
Pressing button B will reset hands G, E and C to zero.
Adjusting the time does not stop the chronograph, but it
does block buttons A and B for as long as the crown is
pulled out.
IMPORTANT: Crown must be in position 1 and hands
must be at zero before chronograph is started. Press
button B to reset hands to zero. DO NOT push button
A or B while crown is pulled to position 2 or 3. If
button A or B is accidentally activated while crown is
not flush against case, one or more of the chronograph
hands will become de-synchronized. Should this occur,
follow instructions below.
Synchronization of chronograph hands:
After changing the battery, or in the event of an error,
the chronograph hands can be realigned to zero if
needed. A single push (quick press and release) will
advance hands by one increment. To advance hands
rapidly, depress and hold push buttons for longer than
one second.
Crown position 2:
Adjust minute-recorder hand E using button B.
Crown position 3:
Adjust chronograph seconds hand C using button A.
Adjust tenths-of-a-second hand G using button B.
OPERATING THE CHRONOGRAPH
Simple chronograph functions:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph.
3. Press button B to reset chronograph to zero.
Accumulated time functions:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph.
3. Press button A again to resume measurement.
QUARTZ CHRONOGRAPH
1/10 OF A SECOND – TYPE B
17
4. Press button A a fourth time to stop chronograph
again.
NOTE: Each time you stop chronograph, chronograph
hands will indicate total accumulated time.
5. Repeat steps 1 and 2 to add each additional
interval of time.
6. After you have taken your final accumulated time
reading, press button B to reset chronograph hands
to zero.
Split-time or intermediate time functions:
You can take intermediate time readings as a race
progresses with these models:
1. Press button A to start chronograph.
2. Press button B to momentarily stop chronograph.
3. Read off the intermediate time, for example: 10
minutes, 26 seconds, 3/10 of a second.
4. Press button B to resume chronograph function.
Hands will catch up with ongoing event.
5. To read a second split time, press button B again.
Repeat steps 2 through 4 to take any additional split
times.
6. Press button A to stop chronograph.
7. Take a reading of the final time, for example: 27
minutes, 3 seconds, 7/10 seconds.
8. Press button B to reset chronograph hands to zero.
First place and runner-up results:
These chronograph models also allow you to measure
both a winning time and runner-up results:
1. Start chronograph by pressing button A.
2. As soon as winner crosses finish line, press button B.
Chronograph will stop.
3. When second runner crosses finish line, press
button A.
4. Note time for the winner as shown on the dial.
5. Press button B; hands will move up to indicate time
for the runner-up.
6. Press button B again to return all hands to zero.