Swiss Movado Operating Instructions Warranty & Service Manual page 13

LEGEND:
H – Hour hand
M – Minute hand
S – Small seconds hand
C – Chronograph retrograde 30-seconds counter
E – Chronograph retrograde 60-minutes counter
F – Chronograph retrograde 5-minutes counter counter
D – Date window
1, 2, 3 – Crown positions
A – Chronograph push-button (start/stop)
B – Chronograph push-button (split-time/reset)
This chronograph model features a center-mounted
retrograde seconds counter (up to 30), two retrograde
minutes counters (up to 5 and up to 60), a small
seconds subdial, and date window. It can be used to
time an event up to 1 hour, 5 minutes and 59 seconds
in duration to the nearest second. The chronograph will
stop automatically after 2 hours.
TIME/DATE SETTING
Crown positions:
Position 1 - Normal running position.
Crown screwed-down into case.
QUARTZ CHRONOGRAPH
1/1 OF A SECOND – TYPE B
Includes the series 800 sub-sea retrograde chronograph
FIGURE 5
Position 2 - To set DATE:
Rotate crown clockwise.
Position 3 - To set TIME:
Rotate crown in either direction.
To adjust the time:
1. Unlock screw-down crown. See "Screw-down
Crown" for instructions.
2. When small seconds hand S reaches <<60>>
position, pull crown out to position 3; watch stops.
3. Turn crown in either direction to move hands and set
time, making sure date changes at midnight,
not noon.
4. Push crown back in to position 1, and screw back
down into case . See "Screw-down Crown" for
instructions. Watch will restart, now set to correct
time.
To correct the date (quick mode):
1. Unlock screw-down crown. See "Screw-down
Crown" for instructions.
2. Pull crown out to position 2; watch continues to run.
3. Turn crown clockwise until correct date appears in
window D.
4. Push crown back in to position 1, and screw back
down into case. See "Screw-down Crown" for
instructions.
CHRONOGRAPH FUNCTIONS
Overview
Use buttons A and B to operate the chronograph.
Pressing button A the first time will start the
chronograph. Pressing button A a second time will
stop the chronograph, allowing elapsed time to be
read. Pressing button A a third time will restart the
chronograph. Pressing button B will reset chronograph
hands C, E and F to zero.
IMPORTANT: Crown must be in position 1, screwed
12