Swiss Movado Operating Instructions Warranty & Service Manual page 12

Includes Series 800 Sub-Sea and Movado BOLD large 43.5MM quartz chronographs
4. Press button B to resume chronograph function. The
3 chronograph hands will quickly catch up with
ongoing event.
5. To read a second split time, press button B again.
Repeat steps 2 through 4 to take any additional
split times.
6. Press button A to stop chronograph.
7. Take a reading of the final time, for example: 2
hours, 14 minutes, 7 seconds.
8. Press button B to reset chronograph hands to zero.
Synchronizing chronograph hands:
After a battery change or in the event of an error,
you may need to manually adjust one or more of the
chronograph hands to align them all correctly at their
zero positions.
NOTES: Once in corrective mode, each press
and release on push-button A will advance active
chronograph hand by one increment. To advance
hand rapidly, depress and hold push-button A. You
may exit correction mode at any time in the sequence
by returning crown to position 1 (and screwing it back
down into the case).
1. Pull unlocked screw-down crown out to position 3.
2. Press and hold push-buttons A and B simultaneously
for at least 2 seconds to enter corrective mode.
When chronograph seconds hand C rotates 360°,
corrective mode is activated; release buttons A
and B.
3. Adjust center-mounted chronograph seconds hand C
using push-button A.
4. When hand C reaches zero position, press push-
button B.
5. Now press push-button A to adjust minute counter
hand E.
6. When hand E reaches zero position, press push-
button B.
7. Use push-button A again to adjust hour counter
hand F.
QUARTZ CHRONOGRAPH
1/1 OF A SECOND – TYPE A
11
8. When hand F reaches zero position, push crown
back in to position 1 (and screw back down into
case). Timing hands are now synchronized at zero
position, and chronograph is ready for use.