Swiss Movado Operating Instructions Warranty & Service Manual page 25

5. Proceed to time setting.
Checking/changing time display mode:
The digital time can be displayed in either 12-hour
(AM/PM) or 24-hour mode:
1. With crown in position 1, select T2 function.
2. Push crown in once: If letter A or P appears, the
time is being displayed in the 12-hour mode.
NOTE: When in 12-hour display mode, a small letter P
appears next to the numerals indicating the time when
it is between noon and midnight.
3. Push crown in twice to return to/select 24-hour mode.
DIGITAL TIME AND DATE SETTING
Setting the hours and minutes:
1. Select and display local time.
2. Pull crown out to position 2: the symbol T appears
in upper display; the numerals indicating hours and
minutes flash in lower display.
3. Turn crown in either direction to change the lower
digital time display: a rapid rotation changes the
hour display; a slower rotation adjusts the minute
display.
NOTE: Analog watch hands will move in synch with
digital time display.
4. When correct hours and minutes appear in lower
digital display, push crown back to position 1.
Setting the exact second:
1. Select and display local time.
2. Pull crown out to position 2: the symbol T appears
in upper display; the numerals for hours and minutes
flash in lower display.
3. Push crown in to position 1: The numerals
displaying the seconds will flash for 1 minute.
4. While the seconds are flashing, take an accurate
time signal (from a radio news station, for example).
The instant the audible tone signals the exact time,
push crown in to position 0. The numerals displayed
ANA-DIGI QUARTZ CHRONOGRAPH
1/100 OF A SECOND
Includes the Movado Dura ana-digi quartz chronograph
for the seconds will reset to zero (00).
NOTE: If the numerals have been flashing between
0 and 30 seconds when you push the crown to reset
the seconds, the time will be set to the current minute.
If the seconds have been flashing between 31 and 60
seconds before you push the crown, the time will be
adjusted to the next minute. Once the seconds are set,
check the display and if necessary, correct the time if
by plus/minus one minute.
Setting the date and month:
1. Select the Seconds/Date function.
2. Pull crown out to position 2: The seconds will
disappear; the numeral for the month appears next
to the date; both numerals flash.
3. Turn crown in either direction: A rapid rotation
changes the month; a slow rotation changes the date.
4. Push crown back in to position 1 (neutral position):
The month display disappears and the seconds
display reappears.
NOTE: Even though the month is not displayed while
the watch is being used in normal mode, it must be set
for the perpetual calendar function (up to 2099) to
work properly.
Correcting the day:
1. Select the Day-Date function.
2. Pull crown out to position 2: A letter indicating
the language in which the day is displayed (E =
English, F = French, S = Spanish, D = German)
appears in place of the date; the language and
year flash.
3. Turn crown in either direction to reach desired
language and year: A rapid rotation changes the
language; a slow rotation changes the year..
4. Push crown back in to position 1 (neutral position):
The language and year disappear; the day of the
week and date reappear.
NOTE: If the date, month and year are set, the correct
24