Swiss Movado Operating Instructions Warranty & Service Manual page 14

down into case, and counter hands must be at zero
before chronograph is started. Press button B to reset
hands to zero, or, if necessary, reset them following
instructions below.
To reset chronograph counters to zero:
All chronograph hands must be in the zero position
before you start a timing. Unlock crown and follow
these steps as needed to reset the hands of the
counters:
60-Minutes counter:
Pull crown to position 2, press and hold push-button B
and rotate crown clockwise.
30-Seconds counter:
Pull crown to position 3, press and hold push-button A
and rotate crown clockwise.
5-Minutes counter:
Pull crown to position 3, press and hold push-button B
and rotate crown clockwise.
Simple chronograph functions:
To measure the duration of a single, non-stop event:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph,
and read the chronograph hands to determine
elapsed time, for example: 5 minutes, 57 seconds.
3. Press button B to reset chronograph hands to zero.
Accumulated time functions:
To measure the combined time of a series of shorter
events, for example the actual playing time of a
football game, where play is repeatedly interrupted:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph
and read elapsed time
3. Press button A again to resume measurement.
4. Press button A a fourth time to stop chronograph
QUARTZ CHRONOGRAPH
1/1 OF A SECOND – TYPE B
Includes the Series 800 Sub-Sea retrograde chronograph
again, and read new elapsed time.
NOTE: Each time you stop chronograph, chronograph
hands will indicate total accumulated time.
5. Repeat steps 1 and 2 to add each additional
interval of time.
6. After you have taken your final accumulated time
reading, press button B to reset chronograph hands
to zero.
Split-time or intermediate-time functions:
To take intermediate time readings as a race
progresses: 1. Press button A to start chronograph.
2. Press button B to momentarily stop chronograph.
3. Read off the intermediate time, for example: 6
minutes, 4 seconds.
4. Press button B to resume chronograph function; the
3 chronograph hands will quickly catch up with
ongoing event.
5. To read a second split time, press button B again.
Repeat steps 2 through 4 to take any additional split
times.
6. Press button A to stop chronograph.
7. Take a reading of the final time, for example: 25
minutes, 18 seconds.
8. Press button B to reset chronograph hands to zero.
13