Swiss Movado Operating Instructions Warranty & Service Manual page 16

Table of Contents

Advertisement

chronograph and move hand G to the relevant tenth-of-
a-second mark. Pressing button B will reset hands G, E
and C to zero.
IMPORTANT: Crown F must be in position 1, and hands
must be at zero before the chronograph is started. If
necessary, press button B to reset to zero. DO NOT use
chronograph while crown is pulled out to position 2 or
3. DO NOT operate chronograph buttons A and B
while the timepiece is under water.
NOTE: Adjusting the time does not stop the
chronograph, but it does block buttons A and B for as
long as the stem of crown F in pulled out.
Simple chronograph functions:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph.
3. Press button B to reset chronograph to zero.
Split-time functions:
You can take intermediate time readings as a
race progresses:
1. Press button A to start chronograph.
2. Press button B to momentarily stop chronograph.
3. Read off the intermediate time.
4. Press button B to resume chronograph function.
Hands will catch up with the ongoing event.
5. To read a second split time, press button B again.
Repeat steps 2 through 4 to take any additional split
times.
6. Press button A to stop chronograph.
7. Take a reading of the final time.
8. Press button B to reset chronograph to zero.
First place and runner-up results:
These chronograph models also allow you to measure
both a winning time and runner-up results:
1. Press button A to start chronograph.
2. As soon as the winner crosses finish line, press
button B. The chronograph will stop.
QUARTZ CHRONOGRAPH
1/10 OF A SECOND – TYPE A
Includes the Movado Junior Sport quartz chronograph
3. When the second runner crosses finish line, press
button A.
4. Note the time for the winner as shown on the dial.
5. Then press button B; the hands will move up to
indicate the time for the runner-up.
6. Press button B again to return all hands to zero.
Synchronization of chronograph hands:
After changing the battery, or in the event of an
error, the chronograph hands can be realigned to zero
if needed:
Crown position 2:
Adjust minute-counter hand E using button B.
Crown position 3:
Adjust chronograph seconds hand C using button A.
Adjust tenths-of-a-second counter hand G using button B.
To advance hands rapidly, press push buttons and hold
longer than one second.
15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents