1/10 Second - Type D - Swiss Movado Operating Instructions Warranty & Service Manual

NOTES: If date is adjusted between 9:00 PM and
12:00 AM when automatic date changes are already
in progress, it should be set to the following day: The
date will not automatically advance at midnight if it has
been corrected via quick mode during these hours.
If crown is turned too rapidly during quick mode date
setting, the date may not change properly at midnight.
To correct the date manually, pull crown out to position
2, turn it clockwise until correct date appears in
window; then return it to position 1.
Setting date/time following a battery change:
For models without date, follow To set the time
instructions above.
For models with Big Date feature at 12 o'clock (see
Figure 8A):
1. Pull crown out to position 2; watch continues to run.
2. Turn crown clockwise until yesterday's date appears
in window D.
3. Pull crown out to position 3; watch stops.
4. Turn crown clockwise until today's date appears in
window D.
5. Continue to turn crown clockwise until hands
indicate correct time.
NOTE: Be sure to take AM/PM into account when
setting time.
6. Push crown back in to position 1.
CHRONOGRAPH FUNCTIONS
Overview
Use buttons A and B to operate the chronograph.
Pressing button A the first time will start the
chronograph. Pressing button A a second time will
stop the chronograph, allowing elapsed time to be
read. Pressing button A a third time will restart the
chronograph. Pressing button B will reset chronograph
hands C, E and F to zero. Adjusting the time does not
stop the chronograph, but it does block buttons A and
B for as long as the crown is pulled out.
QUARTZ CHRONOGRAPH
1/10 SECOND – TYPE C
Includes Datron and Sapphire Synergy quartz chronographs
NOTE: Crown must be in position 1 and hands must
be at zero before chronograph is started. Press button
B to reset hands to zero.
IMPORTANT: Do not push button A or B when crown
is pulled out to position 2 or 3. If button A or B is
accidentally activated while crown is not flush against
case, one or more of the chronograph hands may
become de-synchronized. Should this occur, follow
instructions at end for synchronizing chronograph
hands.
Simple chronograph functions:
To measure the duration of a single, non-stop event:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph,
and read the 3 chronograph hands to determine
elapsed time, for example: 4 minutes, 38 seconds,
7/10-of-a-second.
3. Press button B to reset chronograph hands to zero.
Accumulated time functions:
To measure the combined time of a series of shorter
events, for example the actual playing time of a
football game, where play is repeatedly interrupted:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph
and read elapsed time, for example: 15 minutes,
5 seconds.
3. Press button A again to resume measurement.
4. Press button A a fourth time to stop chronograph
again, and read new elapsed time, for example:
28 minutes, 10 seconds.
NOTE: Each time you stop chronograph, chronograph
hands will indicate total accumulated time.
5. Repeat steps 1 and 2 to add each additional
interval of time.
6. After you have taken your final accumulated time
reading, press button B to reset chronograph hands
to zero.
19