Measurement State; Measurement Modes - EDAN H100B User Manual

H100B Pulse Oximeter User Manual

If the POST is successfully finished, the
oximeter sounds a tone and enters the main
interface.
If there is an error during the POST, the following error
codes will display on the screen:
Error code
Error 01
Error 02
Error 03

3.2 Measurement State

3.2.1 Measurement Modes

There are two measurement modes which are waveform
mode and large numeric mode. By default, the
configuration is waveform mode.
Waveform Mode
In the normal measurement state, oximeter can measure
Figure 3-2 Model
Indication
Indicates error for low battery
Indicates error for SpO
Indicates error for main control board
- 32 -
board
2