Starting A Drying Programme - Electrolux EDI 96150 W User Manual

125986590.qxp 2007-01-29

Starting a drying programme

Press the START/PAUSE button. The
programme is started.
The programme progress display
shows drying progress. The symbols
for DRYING and
appear in the display one after the
other. The number of droplets in the
dryness indicator gradually goes down
as the drying process progresses.
Changing a programme
To change a programme which has
been selected by mistake once the
programme has started, first turn the
programme selector to O OFF and
then reset the programme.
The programme can no longer be
changed directly once the programme
has started. If you nevertheless attempt
to change the programme with the
programme knob or an additional
function button (except the BUZZER
button), the START/PAUSE button and
Err will flash in the display. The drying
programme is not however affected by
this.
Putting in extra items or taking
items out before end of programme
1. Open door.
Warning! Laundry and drumcan bec
ome hot.Risk of burns!
2. Load or remove laundry items.
10:50 Page 27
starting a drying programme electrolux 27
3. Close the door securely. Lock must
audibly lock.
4. Press the START/PAUSE button to
continue the drying cycle.
Drying cycle complete /
COOLING removing laundry
Once the drying programme has
finished,
in the display. If the
activated, an audible signal sounds at
regular intervals.
The drying cycle is automatically
followed by a anti-c c rease phase which
lasts around 30 minutes.
The drum rotates at intervals during
this phase. This keeps the laundry
loose and free of creases. It can be
removed at any time during the anti-
crease phase. (The laundry should be
taken out towards the end of the anti-
crease phase at the latest to prevent
creases from forming.)
1. Open door.
2. Before removing the laundry, remove
fluff from the micro-fine filter. It is best
to use a damp hand for this purpose.
(See "Cleaning and maintenance"
section.)
3. Remove laundry.
5. Turn the programme knob to O OFF.
Important! After each drying cycle
– Clean the micro-fine filter and fine
filter
– Drain the condensed water container
(See section "Cleaning and
maintenance".)
6. Close door.
CREASE GUARD lights up
BUZZER is