Starting A Programme; Programme End - Electrolux TW SL5 E User Manual

18 www.electrolux.com
10.6 Options
Together with the programme you can set
1 or more special options.
To activate or deactivate the option push
the applicable button .
When the option is activated the LED
above the button or symbol on the display
comes into the view.
10.7 Child lock option
The child lock can be set to prevent the
children to play with the appliance. The
child lock option locks all push buttons
and the programme dial (this option does
not lock On/Off (Ein/Aus) button).
You can activate the child lock option:
• before you push the Start/Pause
button - the appliance cannot start
• after you push the Start/Pause button
- programmes and option selection is
off.
Child lock option activation:
1. Turn on the dryer.
2. Wait approximately 8 seconds.
3. Select 1 of the available programmes.
4. Push at the same time and hold down
the Dry Plus (Trocken+) and Anti-
crease (Knitterschutz) buttons .
The drying time you see is
related to the load of 5 kg for
cotton and jeans
programmes. For the other
programmes the drying time
is related to the
recommended loads. The
drying time of the cotton and
jeans programmes with the
load more than 5 kg is longer.
The symbol comes into the view on the
display.
5. To deactivate the child lock, push
again the above buttons until the
symbol goes out of the view.

10.8 Starting a programme

To start the programme:
Push the Start/Pause button.
The appliance starts and the LED above
the button does not flash but is stable.
10.9 Programme change
To change a programme:
1. Push the On/Off (Ein/èus) button to
turn off the appliance.
2. Push again the On/Off (Ein/èus)
button to turn on the appliance.
3. Set a new programme.

10.10 Programme end

Clean the filter and drain the
water container after each
drying cycle. (See chapter
CèRE èND CLEèNING.)
If the drying cycle is completed, the
symbol flashes on the display. If the
éuzzer (Signal) option is on, the acoustic
signal sounds intermittently for 1 minute.
If you do not turn off the
appliance, the crease guard
phase starts. Laundry can be
removed during this phase.
To remove the laundry:
1. Push the On/Off (Ein/èus) button for 2
seconds to turn off the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.