Electrolux EDI 96150 W User Manual page 22

125986590.qxp 2007-01-29
22 electrolux starting an iron aid
Iron Aid TM programme complete
/ removing laundry
After the Iron Aid phase has ended,
0.00 is illuminated and the message
ANTICREASE appears in the display.
If the BUZZER has been activated,
an audible signal sounds at regular
intervals.
The Iron Aid programme is
automatically followed by an anti-
crease phase, including brief steam
phases, which lasts around 90
minutes.
The drum rotates during the anti-
crease phase. This keeps the laundry
loose and free of creases. It can be
removed at any point during the anti-
crease phase, except during steam
phases (look for steam animation in the
display!). Laundry should be removed
as quickly as possible.
10:49 Page 22
tm programme
1. Open the loading door to remove
the laundry.
2. Before removing the laundry, remove
fluff from the micro-fine filter. It is best
to use a damp hand for this purpose.
(See "Cleaning and maintenance"
section.)
3. Remove laundry one garment at a
time.
To retain the effects of the Iron Aid
treatment, clothes must be removed
one garment at a time during the anti-
crease phase and hung immediately on
a clothes hanger to dry (for at least 5-
15 mins, depending on fabric and
selected steam level). Do up the
buttons and tug the garment into
shape, paying particular attention to
cuffs and seams.
4. Turn the programme knob to O OFF.
Important! After each drying cycle
– Clean the micro-fine filter and fine
filter
– Drain the condensed water container
(See section "Cleaning and
maintenance".)
5. Close door.