Exit Selecting - ICP Electronics PSB Form Factor Board SAGP-845EV User Manual

Socket 478 pentium 4/4-m with 10/100 ethernet lan & agp4x vga sbc

Table of Contents

4.15 Exit Selecting

Save & Exit Setup

Pressing <Enter> on this item asks for confirmation:

Save to CMOS and EXIT (Y/N)? Y

Pressing "Y" stores the selections made in the menus in CMOS – a special section

of memory that stays on after the system has been turned off. When the

computer reboots again, the BIOS configures the system according to the Setup

selections stored in CMOS.

Exit Without Saving

Pressing <Enter> on this item asks for confirmation:

Quit without saving (Y/N)? Y

This allows the user to exit Setup without saving any changes in CMOS. The

previous selections remain in effect. This exits the Setup utility and restarts the

computer.

Table of Contents

Do you have a question about the PSB Form Factor Board SAGP-845EV and is the answer not in the manual?