Installing Cisco Secure Acs - IBM Tivoli and Cisco User Manual

Installing Cisco Secure ACS

To install Cisco Secure ACS Version 4.0 software on a machine running a
supported operating system, run the setup.exe program provided with the Cisco
Secure ACS installation software. When you install Cisco Secure ACS, the setup
program uninstalls any previous version of Cisco Secure ACS before it installs
the new version. If you have a previous version, you are given the option to save
and reuse your existing configuration.
For details about the install process refer to the Installation Guide for Cisco
Secure ACS for Windows 4.0, located at:
http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_installation_
guide_book09186a0080533d5e.html
Use a Web interface to configure Cisco Secure ACS. After the initial
configuration, point a Web browser to the IP address of the Cisco Secure ACS,
using port 2002, for example, http://a.b.c.d:2002. The Welcome window opens
(Figure 7-1). Log in and the main menu will be displayed. Use the buttons on the
left frame of this window to select a specific configuration task.
Figure 7-1 Cisco Secure ACS Welcome window
215
Chapter 7. Network enforcement subsystem implementation