Table of Contents
Advertisement
7. In the IBM Security Solution for Cisco Networks window (Figure 6-76), ensure
that the box Select the checkbox to install IBM Integrated Security
Solution for Cisco Networks is checked, then click Next
Figure 6-76 The IBM Integrated Security Solution for Cisco Networks window
8. In the client communication mode window, select the port on which the client
listens for requests. The default port is 1950.
The client can operate in one of these communication modes:
Push
Pull
Accept the defaults and click Next.
206
Building a Network Access Control Solution with IBM Tivoli and Cisco Systems
This is the mode in which communication can be initiated from
both sides, client and server. This is the recommended mode for
workstations, as only this mode enables the client to use DHCP
administered IP addresses.
In this mode the client listens for server requests, but the server
always initiates communication sessions. This setting is useful
for traffic across a firewall, but only for static IP addresses.
Note: Push mode is the more scalable approach. Use pull mode only when
absolutely required.
Advertisement
Table of Contents
