Section Iv - Test Procedures; Drive Motor - Amana LG4219*2 Service Manual

a W A R N I N G
To reduce the risk of electric shock, fire, explosion, serious injury or death:
•Disconnect electric power to the dryer before servicing.
•Close gas shut-off valve to gas dryer before servicing.
•Never start the dryer with any guards/panels removed.
•Whenever ground wires are removed during servicing, these ground wires must be
a W A R N I N G
reconnected to ensure that the dryer is properly grounded.
To reduce the risk of electric shock, fire, explosion, serious injury or death:
•Disconnect electric power to the dryer before servicing.
•Close gas shut-off valve to gas dryer before servicing.
•Never start the dryer with any guards/panels removed.
•Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
IMPORTANT: Electrical test procedures in this
service manual are performed by using a Volt-
Ohm meter. Tests can also be performed using a
multi-meter or any other electrical testing
equipment with which the service person is
familiar.
SECTION IV
Test Procedures
Figure 49
49
48. DRIVE MOTOR (Figure 49)
a. Remove motor and exhaust assembly,
paragraph 30.
b. Disconnect motor wire harness at motor
disconnect block.
NOTE: Refer to appropriate wiring diagram when
rewiring motor switch.
W001
W001
RS3200001 (502992R3)
Rev. 3