Door Hinge; Hold-Down Clips And Guide Lugs - Amana LG4219*2 Service Manual

a W A R N I N G
To reduce the risk of electric shock, fire, explosion, serious injury or death:
•Disconnect electric power to the dryer before servicing.
•Close gas shut-off valve to gas dryer before servicing.
•Never start the dryer with any guards/panels removed.
•Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.

22. DOOR HINGE

a. Open loading door and, while supporting door,
remove four screws holding door assembly to
hinges, Figure 23.
b. Remove four screws holding hinges to front
panel, Figure 23.

23. HOLD-DOWN CLIPS AND GUIDE LUGS

a. While supporting the lower access panel,
remove two screws from bottom edge of lower
access panel, Figure 22.
b. Gently lower the access panel to disengage
guide lugs from bottom edge of front panel.
RS3200001 (502992R3)
Rev. 3
c. Remove two screws holding bottom tabs on
front panel to dryer side panels, Figure 22.
Swing bottom edge of front panel away from
dryer far enough to disengage hold-down clips
and guide lugs from cabinet top.
d. Disconnect wires from door switch, Figure 21.
NOTE: Refer to appropriate wiring diagram when
rewiring switch.
e. Compress hold-down clips and remove from
slot in top flange of access panel or front
panel.
f. Remove four screws holding four guide lugs
to access panel or front panel, Figure 22.
Figure 23
22
W001