Burner Housing And Heat Shroud; Limit Thermostat; Heating Element - Amana LG4219*2 Service Manual

a W A R N I N G
To reduce the risk of electric shock, fire, explosion, serious injury or death:
•Disconnect electric power to the dryer before servicing.
•Close gas shut-off valve to gas dryer before servicing.
•Never start the dryer with any guards/panels removed.
•Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.

25. BURNER HOUSING AND HEAT SHROUD

a. While supporting the lower access panel,
remove two screws from bottom edge of lower
access panel, Figure 22.
b. Gently lower the access panel to disengage
guide lugs from bottom edge of front panel.
c. Disconnect igniter wires at disconnect blocks,
sensor wires from flame sensor terminals, and
wires from gas valve coils at the quick
disconnect blocks, Figure 24.
d. Remove screw from right side of burner
housing, while holding burner tube in place,
Figure 26.
e. Gently move burner tube toward rear of dryer
to disengage tab from slot on left side of
burner housing, Figure 24.
f. Carefully rotate burner tube and igniter
counterclockwise so tab is at 8 o' clock
position.
g. Move air shutter end of burner tube slightly to
right and CAREFULLY remove burner tube
and igniter assembly out through front of
dryer.
IMPORTANT: The igniter is very fragile. Be
careful not to damage it during removal.
h. Remove screw holding burner housing to heat
shroud, Figure 24.
i. Remove screw holding front of burner housing
to dryer base and remove housing out
through front of dryer, Figure 26.
j. Remove two screws holding shroud to heater
box and take shroud out through front of
dryer.

26. LIMIT THERMOSTAT

a. While supporting the lower access panel,
remove two screws from bottom edge of lower
access panel, Figure 22.
b. Gently lower the access panel to disengage
guide lugs from bottom edge of front panel.
c. Disconnect wires and remove screws
attaching limit thermostat to burner housing or
element plate, Figure 26.

27. HEATING ELEMENT

a. While supporting the lower access panel,
remove two screws from bottom edge of lower
access panel, Figure 22.
b. Gently lower the access panel to disengage
guide lugs from bottom edge of front panel.
c. Remove two screws holding element and
plate to heater box and pull element down
and away from heater box, Figure 26.
d. Disconnect wires from element and plate,
Figure 26.
e. Remove screws holding thermostat and
thermal fuse to element and plate, Figure 26.
NOTE: When reassembling, be sure all wire
connectors are tight on element terminals,
thermal fuse and limit thermostat.
Figure 26
25
W001
RS3200001 (502992R3)
Rev. 3