Front Panel And Panel Seal; Door Switch; Strike Catch - Amana LG4219*2 Service Manual

a W A R N I N G
To reduce the risk of electric shock, fire, explosion, serious injury or death:
•Disconnect electric power to the dryer before servicing.
•Close gas shut-off valve to gas dryer before servicing.
•Never start the dryer with any guards/panels removed.
•Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.

19. FRONT PANEL AND PANEL SEAL

a. While supporting the lower access panel,
remove two screws from bottom edge of lower
access panel, Figure 22.
b. Gently lower the access panel to disengage
guide lugs from bottom edge of front panel.
c. Remove two screws holding bottom tabs on
front panel to dryer side panels, Figure 22.
Swing bottom of front panel away from dryer
far enough to disengage hold-down clips and
guide lugs from cabinet top.
d. Disconnect wires from door switch, Figure 21.
NOTE: Refer to appropriate wiring diagram when
rewiring switch.
e. Remove front panel seal from flange around
inside of door opening, Figure 22.
NOTE: Be sure seal is properly positioned when
installing on front panel.
Figure 21
RS3200001 (502992R3)
Rev. 3

20. DOOR SWITCH

a. While supporting the lower access panel,
remove two screws from bottom edge of lower
access panel, Figure 22.
b. Gently lower the access panel to disengage
guide lugs from bottom edge of front panel.
c. Remove two screws holding tabs on front
panel to dryer side panels, Figure 22. Swing
bottom of front panel away from dryer far
enough to disengage hold-down clips and
guide lugs from cabinet top.
d. Disconnect wires from door switch, Figure 21.
NOTE: Refer to appropriate wiring diagram when
rewiring switch.
e. Depress tabs on top and bottom of switch and
push out of front panel, Figure 21.

21. STRIKE CATCH

a. While supporting the lower access panel,
remove two screws from bottom edge of lower
access panel, Figure 22.
b. Gently lower the access panel to disengage
guide lugs from bottom edge of front panel.
c. Remove two screws holding bottom tabs on
front panel to dryer side panels, Figure 22.
Swing bottom of front panel away from dryer
far enough to disengage hold-down clips and
guide lugs from cabinet top.
d. Disconnect wires from door switch, Figure 21.
NOTE: Refer to appropriate wiring diagram when
rewiring switch.
e. Depress tabs on top and bottom of catch and
push out of front panel, Figure 21.
20
W001